Thursday 18 February 2016

176 - Build, Build, Build

Has only one seen my mojo? My painting mojo? Nope, didn't think so. Never mind. Luckily my building mojo is here and it's been in full flow.

I started off with something simple and added some ForgeWorld armour plates to my Capricorn Chimera conversion.

Nothing too fancy but gives this Chimera a bit of a meaner profile and works nicely with the autocannon turret.

Next up was another Capricorn Chimera conversion. This one again wasn't anything too complicated. I built the Chimera kit up as per normal and then added the Capricorn rear hull piece.

I also added a ForgeWorld rear door.

I did have some issues with the Chimera turret fitting. I started off by removing the locking pieces to just have the circle plastic left. Unfortunately, the turret kept wobbling and wouldn't stay up properly, even with a bit of weight in the back. To fix this, I bought some nylon washers off eBay which had the right size cylinder to fit in the Capricorn turret hole (after some gentle (aggressive) sanding of the hole). With the washer rotating easily,


I completely removed the plastic nub from the bottom of the turret and stuck the turret to the washer. Now the turret fits nicely and doesn't fall forward.

For once I took some pictures of how I magnetise things. To start, I mark off how much space the magnet will need and then remove the plastic that is in the way using a combination of hobby knife and file. Once the plastic has been removed, I dry fitted the magnets and removed some more plastic if necessary. To make sure the magnets were placed the correct way up, I marked the top using a blue pen before applying a large amount of super glue and carefully placing them down.

While waiting for the super glue to dry completely, I started on the underside of the tank chassis. Using one of the magnets, I marked out how much of the guide plastic I would need to remove at both the front and back. With this removed, I checked the fit for the magnet and removed more if needed. It was a bit trickier getting the guide off due to it's location - hence it being a bit untidy.

To get the magnets in the right place on the inside of the tank, I held the dozer blade in it's correct position and then placed a magnet in each corner. Using a pen, I drew around each magnet and marked the visible side of them. I removed one magnet and applied some super glue, then went to the opposite magnet and did the same and then repeated for the remaining 2. Once the glue had dried, the other side of the tank is glued on.

As well as getting on with building, I've also been buying and I grabbed a ForgeWorld Artemia Pattern Hellhound off eBay. The paint isn't too thick so it shouldn't be too bad to strip off.

The Inferno Cannon needs a bit of straightening out and there are a couple of gaps on the chassis, but this should be a relatively quick clean up. I'll be going for a camo pattern on this one instead of leaving it plain like the other hellhound Ambustio - it might even get a bit of extra armour.

The Hellhound wasn't the only purchase off eBay. I grabbed 42 built guardsmen with a variety of weapons. These guys need their mould lines removing and it will be a test for me to paint something that is already constructed - these will be added to the mound of infantry to be completed.

There are also two Taurox (Tauroxes?) waiting to be built and another Valkyrie.

I've got an urge to finish off the Purple Knight so I may finally get some painting done.

Thanks for reading!

5 comments:

Mordian7th said...

Nice builds mate - I always loved the set-back turret chimera look. Good stuff!

Zzzzzz said...

Nice to see the force build up. Looking forward to the new group photo !

Cadian 127th said...

@ Mordian7th - cheers, the Capricorn kit makes it so much easier, but I am tempted to build some myself again.

@ Zzzzzz - cheers, might need to paint some up before another group photo is done!

Admiral Drax said...

Been too long since I surfed the blogs..! Great building there, mate: that side armour makes the chimera look properly mean!

Cadian 127th said...

@ Admiral Drax - I considered putting it on all of the Chimera's but having it on one or two will make it stand out more.

Copyright © 2012 Cadian 127th Regiment All Right Reserved