The internal supports took a magnet pretty easily.

The mortar itself had some locating pins that were cut off and smoothed down before I added a suitably sized magnet on.

Thanks for taking the time to stop by.

I had a bit of spare time so continued with a tiny bit of progress on the Hellhound. In case you've missed the start of this, take a look at Part 1 & Part 2. 

The promethium tank has been glued in place and only required a small amount of filing on the bottom in order to make it sit flat. The track guards were also tidied up and glued in place.

The green stuff filling was given a quick going over with some fine sandpaper to remove the worst of the rough finish. I didn't spend ages on sanding so hopefully that won't come back to bite me later on. The turret is still loose and will not be glue in place - though I may magnetise the guide peg. I've still got to tackle that wonky barrel as well. Some careful bending will be required as it seems a bit twisted as well.

Not content with one ForgeWorld model to deal with, I bought another one. 

This time round though it's a discontinued Vanaheim Pattern Griffon Mortar. Not a bad find and still a cool looking model.

The Chimera base had been put together and the only resin that has been attached is the base plate/side thing. My only concern is the alignment as the resin isn't level with the inner parts of the Chimera which could make adding the gun shield tricky. Has anyone built one of these before and could offer tips?

Thanks for reading.